Reset Canon iP100
20:42
Edit
Problem:
Waste ink tank full, waste ink pad full, the ink absorber is almost full, error 5B00, error P07, blink 7 times, blink 8 times, the ink absorber becomes almost full, error E08, error E07, error 6C10, error 5B02.
Printer:
Canon iP100
Reset Canon iP100
Step 1: Enter Service Mode
1. Unplug Power and USB cables.
2. Open door.
3. Press and hold the Power button.
4. Connect the Power cable.
5. Close door and then release Power button.
6. Turn ON printer as usual and it should be not blinking more.
7. Connect the USB cable.
If after follow points 1-6 the green light not constantly but the printer continues to show an error, it's mean you made a mistake in points 1-6. Turn off the printer and repeat step 1.
Step 2: Reset Canon P100
To reset the Canon P100 can be done with (select one):
a. Manual
b. General Tool v1.01
a. Manual reset
8. Press the Stop/Reset button 4 times (each time the Stop/Reset button is pressed, the power indicator changes color).
9. Press the On/Off button 1 time to confirm the selected action (reset the absorber counter).
10. Press the On/Off button 2 times to turn off the printer.
11. Turn on the printer and now the printer is ready for use.
Another command for points 8:
Press the Stop/Reset button: 1 times – Orange – Service test print (load paper before do it)
Press the Stop/Reset button: 2 times – Green – EEPROM information print (load paper before do it)
Press the Stop/Reset button: 3 times – Orange – EEPROM initialization
Press the Stop/Reset button: 4 times – Green – Waste ink counter setting
Press the Stop/Reset button: 5 times – Orange – Destination setting (then Press Power, Press Stop/Reset 3x)
Press the Stop/Reset button: 6 times – Green – Print head deep cleaning
Press the Stop/Reset button: 11-13 times – Orange, Green, Orange – Return to menu selection
Press the Stop/Reset button: 14 times – Green – Left margin correction
b. Reset with General Tool v1.01
· Extract file and open General Tool.
· Select USB Port (1)
· Set Destination 1 (2)
· Load paper to the printer
· Check EEPROM CLEAR (3)
· Test Pattern 1 (4), wait for the printer to finish printing
· Close General Tool (5)
· Turn off printer (wait 10 seconds)
· Turn on printer.
· Printer ready for use.